a
abdul_haseebb_

Abdul Haseeb

@abdul_haseebb_

Electrical Engineer 'PCB Design, Embedded Systems and MATLAB Simulink'

Pakistán
Inglés, Urdu, Hindi
Parte de la información aparece en idioma inglés.
Sobre mí
Electrical engineer who designs, simulates and builds electronic systems end to end. 1- PCB design (KiCad): mixed-signal, isolated and mains-powered boards, Gerbers and BOM ready for JLCPCB 2- Embedded: ESP32, STM32 and Arduino firmware in C/C++, ADC data acquisition, Ethernet and IoT 3- Simulation: MATLAB/Simulink, power electronics (converters, rectifiers) and PI/PID control; Proteus circuits 4- Analog: op-amp and instrumentation-amp signal conditioning 5- Testing: bring-up and debugging with oscilloscope and multimeter Final-year EE student at NUST with R&D and industrial internships.... Lee más

Habilidades

a
abdul_haseebb_
Abdul Haseeb
desconectado • 
Tiempo medio de respuesta: 1 hora

Revisa mis servicios

Sistemas integrados e IoT
I will do matlab simulink simulations for power electronics
DeUSD 15 / proyectoMás información

Porfolio

Experiencia laboral

National_University of Sciences and Technology (NUST)

R&D Intern

National University of Sciences and Technology (NUST) • Tiempo completo

Aug 2026 - Sep 2026 • 1 mo

Developed, tested and field-deployed a real-time embedded telemetry system for passive underwater acoustic monitoring. • Bare-metal firmware on an STM32F7 (Nucleo-F767ZI): ADC and timer configuration for continuous acoustic sampling at 400 kSPS, with buffering and real-time packet transmission over Ethernet. • Analog front-end built around an AD8421 instrumentation amplifier for DC offset removal and noise filtering of the acoustic sensor signal. • Buck-converter power supply and an Ethernet-to-fibre media converter for the long cable run to shore, housed in sealed junction boxes. • Solved sampling-versus-transmission timing issues to stream without data loss; validated through extended bench tests, then deployed and verified on site with live spectrogram monitoring.

Artistic_Milliners

Electrical Engineering intern

Artistic Milliners • Tiempo completo

Jul 2026 - Aug 2026 • 1 mo

Four-week industrial placement in the Electrical Department of a large denim manufacturing facility. • Inspected LT rooms, PFI panels and distribution boards across three sub-units using structured electrical safety checklists • Conducted thermographic surveys, including the solar inverter and battery room, where I identified an AC failure that had raised ambient temperature to about 70°C • Studied a SCADA-based energy monitoring system managing 22 LT panels fed by grid, solar, gas and diesel generation • Worked with single-line diagrams, Lockout/Tagout procedures and hotspot severity classification (C0–C3) • Designed a forward/reverse 3-phase motor control circuit with electrical and mechanical interlocking, as a supervised exercise